Ambient Weather WS-06 User Manual download pdf (Page 6)

Figure 7

4 Console Operation

Note: The console has three buttons for easy operation: SET, CH/+ and MIN/MAX button. The

remaining two buttons have no functionality (the same console is used for different products and

therefore, are not used for this product).

4.1 Set Mode

To enter the Set mode, press and hold the SET key for 3 seconds.

1. 12/24 Hour. 12 Hr or 24 hour will begin flashing. Press the CH/+ button to switch between

12 hour and 24 hour display mode. Press the SET button (do not hold) to advance to the next

setting.

2. Hour of Day. The hour of day will begin flashing. Press the CH/+ button to increase the hour,

and the MIN/MAX key to decrease the hour. Press the SET button (do not hold) to advance

to the next setting.

3. Minute of Day. The minute of day will begin flashing. Press the CH/+ button to increase the

minute, and the MIN/MAX button to decrease the minute. Press the SET button (do not hold)

to advance to the next setting.

4. Temperature Units of Measure. The °F or °C icon will begin flashing. Press the CH/+

button to switch between °F and °C. Press the SET button (do not hold) to exist the Set

Mode.

4.2 Min/Max Mode

The Min/Max mode displays the minimum and maximum indoor and outdoor temperature and indoor

humidity (since reset of the unit) for the indoor, remote channel 1, 2 and 3 sensors.

Prior to entering the MIN/MAX mode, press the CH/+ button to select the temperature values you

wish to view.

1. Display Maximum. Press the MIN/MAX button once to display the maximum. The MAX

icon will be displayed.

2. Clear Maximum. To reset the maximum values to the current values, press and hold the

MIN/MAX key for 3 seconds.

3. Display Minimum. Press the MIN/MAX button again to display the minimum. The MIN

icon will be displayed.

4. Clear Minimum. To reset the minimum values to the current values, press and hold the

MIN/MAX key for 3 seconds.

To return to normal mode, press the MIN/MAX button again, or wait 15 seconds for timeout.

4.3 Indoor/Outdoor Channel Selection

Press the CH/+ button to switch the display between OUT remote sensors 1,2 and 3. Channel 1 is

included with the unit. Channels 2 and 3 are optional sensors and purchased separately.

4.4 Sensor Search Mode

If any of the sensor communication is lost, dashes (--.-) will be displayed on the screen. To reacquire

the signal, press and hold the CH/+ button for 3 seconds, and the remote search icon will be

constantly displayed. Once the signal is reacquired, the remote search icon will turn off, and the

1 2 3 4 5 6 7 8 9 10 11

No comments

Ambient Weather WS-06 User Manual Page 6