Ambient Weather WS-06 User Manual download pdf (Page 5)

Figure 6

1. Time of Day (hh:mm)

2. Temperature Units (°F or °C)

3. Min/Max Record mode

4. Reception Icon (solid when searching,

flashes when updating)

5. Indoor Humidity (%)

6. Indoor Temperature (°F or °C)

7. Outdoor Temperature (°F or °C)

8. OUT Channel 1,2,3 indictor

2.4.2 Sensor Operation Verification

Verify the indoor and outdoor temperature match closely with the console and sensor array in the same

location (about 5 to 10’ apart). The sensors should be within 2°F (the accuracy is ± 1°F). Allow

about 30 minutes for both sensors to stabilize.

3 Remote Sensor Installation

It is recommended you mount the remote sensor on a north facing wall, in a shaded area. Direct

sunlight and radiant heat sources will result in inaccurate temperature readings. Although the sensor is

water resistant, it is best to mount in a well protected area, such as under an eve. Use a screw or nail

(not included) to affix the remote sensor to the wall, as shown in Figure 7.

1 2 3 4 5 6 7 8 9 10 11

No comments

Ambient Weather WS-06 User Manual Page 5