Ambient Weather F007TP User Manual download pdf (Page 6)

Figure 5

1. Indoor Temperature

2. Temperature units (°F or °C)

3. Indoor Relative Humidity (%)

4. Min/Max reset for 24h

5. Min/Max Record mode

6. Outdoor Relative Humidity (%)

7. Outdoor Temperature

8. Channel 1,2,3,4,5,6,7,8, indictor

9. Scroll mode (CH1-8)

2.3.2 Sensor Operation Verification

Verify the indoor and outdoor humidity match closely with the console and sensor array in the same

location (about 5 to 10’ apart). The sensors should be within 10% (the accuracy is ± 5%). Allow

about 30 minutes for both sensors to stabilize. The humidity can be adjusted or calibrated later to

match each other a known source.

Verify the indoor and outdoor temperature match closely with the console and sensor array in the same

location (about 5 to 10’ apart). The sensors should be within 2°F (the accuracy is ± 1°F). Allow

about 30 minutes for both sensors to stabilize. The temperature can be adjusted or calibrated later to

match each other or a known source.

3 Remote Sensor Installation

It is recommended you mount the remote sensor on a north facing wall, in a shaded area. Direct

sunlight and radiant heat sources will result in inaccurate temperature readings. Although the sensor is

water resistant, it is best to mount in a well protected area, such as under an eve. Use a screw or nail

1 2 3 4 5 6 7 8 9 10 11 12 13 14

No comments

Ambient Weather F007TP User Manual Page 6