Version 1.0 ©Copyright 2013, Ambient LLC. All Rights Reserved. Page 4
Table 1
5. Insert two AAA batteries.
6. After inserting the batteries, the remote sensor LED indicator will light for 4 seconds, and
then flash once per 60 seconds thereafter. Each time it flashes, the sensor is transmitting data.
7. Verify the correct channel number (CH) and temperature units of measure (°F vs. °C) are on
the display, as shown in Figure 3.
Figure 3
(1) temperature
(2) temperature units (°F vs. °C)
(3) channel number
8. Close the battery door. Make sure the gasket (around the battery compartment) is properly
seated in its trace prior to closing the door. Tighten the set screw.
3 Remote Sensor Installation
The remote probe sensors have many applications, including measuring inside/outside air temperature,
water temperature, soil or ground temperature and refrigerator / freezer temperatures.
Comments to this Manuals